Caution:
Users can use this function in other work modes like counting pieces,
weighing in percents etc. Only values and units can change.
24.4. Maximal force latch
Procedure:
• Enter the TOP work mode:
• TOP selection is signalled by the Max pictogram in the upper
line of the display:
• When a force acting on the pan changes on the display only
the maximal value can be seen,
• Remove the acting force,
• Press
before the next measurement.
Return to weighing:
See 11.3.
24.5. Counting pieces
The standard software is equipped in a counting pieces procedure.
If counting pieces is to be proceeded in a package/container, tare
the package/container first.
- 103 -
To Next Page
Loading...
