• Press ,
• In the lower line you will see an editing field:
• Inscribe the tare value:
• Press
,
• The scale return to weighings mode The inscribed tare value
can be seen on the display with „–” sign.
Tare can be inscribed anytime in weighings mode.
12.4. Zeroing
To ZERO the scale press: .
The scale will display zero and following pictograms:
and .
Zeroing is only possible within the scope of ±2% of full scale.
While zeroing outside the scope of ±2% you will see Err2.
Zeroing is possible only in stable state.
Notice:
Zeroing is possible only within ±2% of full range around zero. If the zeroed
value is beyond the interval of ±2%, Err2 is displayed and a short beep
sound will be emitted.
- 24 -
To Next Page
Loading...
