After entering the DOSING mode the pictogram is displayed. Press
to start a dosing process. After starting it starts blinking,
keyboard is blocked until the process is completed.
The process completion is signalled by displaying a message:
< END OF DOSING > in the bottom line of the display:
This process can be stopped only by pressing . A message will
be displayed in the bottom line: < STOP DOSING >.
When the procedure is broken or completed is displayed continuously.
Dosing process can be also terminated by pressing
. You will see:
Pressing
will cause the process to continue.
Pressing
will cause the process to break.
Return to weighing:
See 11.3.
- 117 -
To Next Page
Loading...
