15
15
Advanced Options
ESP-Me Advanced User Manual
Total Run Time Calculator
By Program
View the Total Run Time for an entire program.
The controller can determine the Total Run Time of a
program by adding up all the Run Times for each station in
that program.
To Determine Total Run Time By Program:
1. Turn the dial to
Manual Program.
2. The Total Run Time for
PGM A is displayed.
PROGRAM
SELECT
A B C D
MANUAL
PGM
A
MINUTESHOUR
RUN TIME
120
3. Press the Program Select button to view the Total Run
Time for the next program.
REPEAT Step 3 to view Total Run Times for remaining
programs.
NOTE: The run time displayed for each program is
the seasonally adjusted run time and only includes
one start time.
Test All Stations
Verify operation of valves in the system.
SPECIAL FEATURE AVAILABLE
Start a sequential test of every station that has a
programmed Run Time.
NOTE: Any station that has a programmed Run Time
of 0 minutes will not be tested.
1. Turn the dial to Test All Stations.
2. Press or to set the desired Run Time.
MINUTES
TEST 02
3. Press and HOLD the Hold to Manually
Start button to begin watering.
4. Turn the dial to AUTO RUN after the display
shows TESTING.
During Testing:
In AUTO RUN mode, the display shows a blinking sprinkler
symbol, the active Station number and the remaining Run
Time.
5. Press the Advance Station button to advance to the
next station if desired.
6. To cancel the test, turn the controller dial
to OFF for three seconds and then back
to AUTO RUN.
To Next Page
Loading...
Need help?
General
