Raisecom ISCOM5508 - Interfaces; Leds; Figure 2-9 Panel of the GE4 B Sub-Card; Table 2-12 Interfaces on the GE4 B Sub-Card

Raisecom
ISCOM5508 (B) Hardware Description
2 Components
Raisecom Technology Co., Ltd.
13
Figure 2-9 shows the panel of the GE4B sub-card.
Figure 2-9 Panel of the GE4B sub-card
2.4.3 Interfaces
There are 4 interfaces on the GE4B sub-card.
Table 2-12 lists interfaces on the GE4B sub-card.
Table 2-12 Interfaces on the GE4B sub-card
Interface
Type
Usage
Description
GE 1/2/3/4
SFP
1000 Mbit/s Ethernet
service interface
Supported optical module type:
1000BASE-X
Supported electrical module type:
1000BASE-T
Table 2-13 lists parameters of the SFP optical interface.
Table 2-13 Parameters of the 1000BASE-X SFP optical interface
Parameter
Description
Connector
LC/PC
Optical interface properties
Depend on the SFP optical module.
Working mode
Full duplex
Compliant standard
IEEE 802.3
Supported network protocol
IP

For details of the optical module, see chapter 4 Pluggable modules.

When the GE4B card uses the 1000BASE-T electrical module, the interface rate
should be configured to "forced 1000M" mode. For details, see ISCOM5508 (B)
Configuration Guide.
2.4.4 LEDs
There are 6 LEDs on the GE4B sub-card.
Table 2-14 lists LEDs on the GE4B sub-card.