1 | Introduction
80.06.083_iCombiPro-iCombiClassic_IM_en-US 7 / 100
n
The unit must not be used, cleaned or maintained by children. The unit must
not be used as a toy. This is prohibited even under supervision.
n
The unit must not be used, cleaned or maintained by persons with limited
physical, sensory or mental aptitude, or lack of experience or knowledge.
The only exception is if they are supervised by a person responsible for their
safety and have received instruction from this person about the risks associ-
ated with the unit.
n
In order to avoid the risk of accidents or damage to property, the manufac-
turer advises that technicians attend regular training and safety training ses-
sions.
1.3 Copyright
It is not permitted to pass on product-specific information to third parties. We
reserve the right to implement technical developments and changes in the inter-
est of progress. All rights are reserved, including those of translation and repro-
duction.
1.4 Conformity
The conformity of the units refers to the complete unit at the time of delivery. In
the event of upgrades, modifications and connection of additional functions, the
operator is responsible for obtaining an extension of the approvals.
Observe the relevant country-specific and local standards and regulations con-
cerning the installation and operation of commercial cooking units.
Conformity Europe
n
The power connection is established and connected in accordance with IEC
60335, taking into account EN 60335, UL, cUL and VDE 0700.
n
The water connection is established and connected in accordance with IEC
61770, taking into account EN 1717 and EN 13077.
n
The wastewater connection corresponds to the current valid WRAS, SVGW
and KIWA regulations and is tested and certified accordingly.
n
The unit is approved for use up to 4000 m above sea level according to IEC
60335.
Conformity USA and Canada
n
The power connection is built and tested according to UL197 and
CSAC22.2no. 109.
1.5 Liability and warranty conditions
Liability
Installations and repairs that are not carried out by specialist personnel autho-
rized by the manufacturer or not using original service parts, as well as any tech-
nical changes to the unit that are not approved by the manufacturer, can render
the manufacturer’s product liability null and void.