Rauch AXIS-M 20.2 EMC - Page 112

Commissioning A
92
AXIS
AXIS 20.2
6. Remove lubricating nipples
Figure 2: Remove lubricating nipples
7. Remove the spigot protec-
tion and grease the trans-
mission spigot.
8. Push the universal drive
shaft onto the transmission
spigot.
9. Insert a hexagonal screw
through the shaft coupling
and transmission spigot.
If required, use a rubber
hammer for this purpose.
Figure 3: Push the universal drive shaft
onto the transmission spigot
10. Tighten the hexagonal screw
and nut using a size 17
wrench (max. 35Nm).
Figure 4: Tighten the universal drive shaft
K
D
R
C
Q
W
EMC