Rauch MDS 8.2 - Page 77

Fig. 41: Spreading vane adjustment; position B2; A to E: Length adjustment 1 to 6: Angle settings
n
Structure of spreading disc M2
NOTICE!
Environmental damage due to incorrectly installed spreading vanes
An incorrect vane combination can significantly impair the spreading pattern and harm the
environment.
u
Pay attention to the specified vane combination.
u
For each M2 spreading disc (left/right), install only one W spreading vane.
There are two spreading vanes on every spreading disc.
• A spreading vane comprises a main vane with an extension vane.
○ The main vane of the right-hand spreading disc has the designation BR and the
corresponding extension vane has the designation AR.
○ The main vane of the left-hand spreading disc has the designation BL and the corresponding
extension vane has the designation AL.
○ The angle of each spreading vane can be adjusted forward and back, and the length can be
shortened or lengthened.
• With the other spreading vane (W spreader) only the angle can be adjusted; the length is fixed.
9. Spreading operation
MDS 8.2/14.2/18.2/20.2 5902916
77