Instructions for Use MPR1 DATALOGGER
Manufacturer: zwo-399EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9, 2020-10-16
Page 81 of 98
• Messages on the MPR1 when saving data to the PC
Under the following conditions
- The Datalogger has been switched on and is displayed on the start screen.
- The Datalogger is connected with the PC; the correct USB connection is displayed.
- Datalog software has been started up.
- “Save data on PC” has been selected (download).
- Press “Start”.
The following message is displayed on the MPR1 whilst downloading data:
The user can close the message at any time by pressing OK, and can continue working, and may also start
a new measurement. In case of an interruption of the data transmission, the user cannot download the data
currently saved on the MPR1 because the PC does not have the information. In this case, the process has
to be repeated.
This document is for information only
To Next Page
Loading...