5-38
hsb
2
Plus Series Fishfinders
Transferring
Waypoints and
Routes
➤ To send the waypoint list on NMEA:
1. Display the waypoint list as previously described, then press the WAY-
POINT TRANSFER soft key.
2. Press the soft key SEND WPT LIST ON NMEA.
The soft key changes to STOP SENDING WAYPOINTS.
The waypoint and route lists are transmitted from the chartplotter to other
instruments on NMEA.
➤ To receive the waypoint and route lists via
hsb
2
, you must set-up the transfer on
both display units - one unit will send waypoints, the other will receive them.
CAUTION:
Receiving waypoints from another
hsb
2
instrument overwrites any
existing waypoint and route lists.
1. Display the waypoint list as previously described, then press the WAY-
POINT TRANSFER soft key.
2. Press the soft key SEND WPT LIST ON HSB or RECIEIVE WPTS FROM HSB; you
are prompted to confirm.
Press NO to cancel the operation, then ENTER if you wish to remove the
route list.
Press YES to continue. The waypoint list is transmitted to/from the chart-
plotter from/to another instrument on
hsb
2
. While the data is being trans-
ferred the soft key changes to STOP SENDING WAYPOINTS; when the
transfer is complete the soft key is re-displayed.
WAYPOINT
TRANSFER
WAYPOINT
TRANSFER
To Next Page
Loading...
