3-4
hsb
2
Plus Series Fishfinders
Switching the
Display On and Off
Chart Mode (Raychart Models only)
If the display was last used in chart mode before being powered off, it will
return to chart mode the next time it is switched on.
➤ To switch the display on in chartplotter mode, press and hold the POWER key
until the unit beeps. The keys light up, the Raychart graphic is displayed,
followed by the caution:
CAUTION:
Raychart chart displays are based on cartographic data that C-MAP
believes to be accurate. However, you should not rely on these displays as
your primary source of navigation. Rather, your Raychart should be used
only as a backup to official government charts and traditional methods of
navigation.
When you have read and understood the caution, press the CONTINUE soft key.
The chart is displayed.
If this is the first time the chartplotter has been turned on, and no chart card is
installed, the display shows the small-scale world map and the default soft
keys. Otherwise, the display shows the selected chart area and any data that
were displayed when the display was last used.
Figure 3-3: Switch On - Chart Mode
Switch Off
CAUTION:
To provide protection against the damaging effects of UV light, it is
advisable to replace the sun cover provided when the color LCD display is
not in use.
A reminder is displayed when you switch off the color LCD display.
D4277-3
Until unit beeps
To Next Page
Loading...
