If the ‘Off/Not Connected’ message is displayed then the display cannot establish a connection
with your radar scanner:
Ensure that your display and radar scanner are paired correctly and then select
On to power up
your radar
.
If the ‘Radar not found’ message is displayed then power cycle your system and perform the
pairing procedure again. If the radar scanner still cannot be found refer to your Radar’s installation
documentation for further troubleshooting information.
Off
If the ‘Off’ message is displayed then your radar scanner is powered off, select On to power up
your Radar
Standby (Not transmitting)
If the ‘Standby’ message is displayed then select Transmit to begin transmitting.
132
To Next Page
Loading...
