Red Jacket Quick-Set P75S1T2 - Page 4

Table of Contents
iv
Figure
Figure 1. Leak detector and manifold dimensions .................................................5
Figure 2. Floating suction installation .....................................................................6
Figure 3. Floating suction adapter .........................................................................6
Figure 4. Measuring the tank (see Table 2 for adjustment ranges). ......................7
Figure 5. Identifying UMP models by their end view ............................................12
Figure 6. Packer/manifold with piping attaching to UMP .....................................13
Figure 7. Aligning the UMP gasket ......................................................................14
Figure 8. Verifying Pigtail’s Female Connector Is Seated Properly .....................14
Figure 9. Measuring tank .....................................................................................15
Figure 10. Loosening Locking Nut .........................................................................16
Figure 11. Adjusting pump length ..........................................................................16
Figure 12. Attaching Return Line Tubing To Pump ................................................17
Figure 13. Capacitor wiring schematic ...................................................................17
Figure 14. Conduit box wiring ................................................................................19
Figure 15. 230 Vac Remote Control Box with 110 Vac coil - Model 880-041-5 .....20
Figure 16. Suggested Wiring Diagram without Optional Control Box ....................20
Figure 17. 230 Vac Remote Control Box with 110 Vac Coil & Cap -
Model 880-045-5/880-046-5 .................................................................21
Figure 18. 230 Vac Remote Control Box with 230 Vac Coil - Model 880-042-5 ....21
Figure 19. Isotrol to IQ System Wiring - 120 Volt Dispenser Signals .....................22
Figure 20. Isotrol to IQ System Wiring - 230 Volt Dispenser Signals .....................23
Figure 21. Tandem pumps .....................................................................................24
Figure 22. Suggested Wiring for Tandem Pumps ..................................................25
Figure 23. Suggested Wiring For Three Phase Tandem Pumps ...........................26
Figure 24. Functional element cap and adjustment screw .....................................27
Figure 25. Three Phase Pump Wiring Diagram Examples ....................................29
Figure 26. Closing the check valve ........................................................................30
Figure 27. Line test port .........................................................................................31
Figure 28. Packer ...................................................................................................32
Figure 29. Removing the UMP ...............................................................................33
Figure 30. Replacing the gasket ............................................................................33
Figure 31. Verifying pigtail’s female connector is seated properly .........................34
Figure 32. Packer with Functional Element ...........................................................35
Figure 33. Wiring schematic ..................................................................................38
Figure 34. Yoke assembly and conduit box part identification ...............................40
Figure 35. Packer-Manifold Assembly Top View - Part Identification ....................41
Figure 36. Packer-Manifold Assembly Side View- Part Identification ....................41
Figure 37. Pump parts ...........................................................................................43
Figure 38. 880-041-5/880-042-5 control box .........................................................46
Figure 39. 880-045-5/880-046-5 control box .........................................................47
Tables
Table 1.- Maximum Specific Gravity and Maximum Viscosity ..................................4
Table 2.- Distance From Eye Bolt to Inlet .................................................................8
Table 3.- Electrical Service Information (Use for UMPs Containing a
Franklin Motor with End View A) ...............................................................9
Table 4.- Electrical Service Information (Use for UMPs Containing a
Faradyne Motor with End View B) ...........................................................10
Table 5.- UMP Model Dimensions ..........................................................................11
Table 6.- Applicable UMPs for 4” Standard Packer/Manifolds ...............................13
Table 7.- Approximate Pressures at shut-off ..........................................................28