Regency CV40E-12 - Horizontal Terminations

To Next Page

To Previous Page

City Series CV40E-12 | 45

installation

Notes:

1. Liner sections should be continuous without any

joints or seams.

2. Only Flex pipe purchased from Regency

may be

used for Flex installations

3. Horizontal vent must be supported every 3 feet.

4. Regency

Direct Vent System (Flex) is only

approved for horizontal terminations.

5. Flex system can only be used up to a maximum

continuous vent length of up to 10 feet. If longer

runs are required, rigid pipe must be used.

Horizontal Terminations - Flex Vent 4" x 6-7/8"

These venting systems, in combination with the CV40E/CB40E Direct Vent Gas Fireplace, has been tested and listed as a direct vent heater system by Warnock

Hersey/ Intertek. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in "Exterior Vent Termination

Locations" section.

Regency

Direct Vent (Flex) System Termination Kits include all the parts needed to install the CV40E/CB40E using a exible vent.

FPI Kit # Length Contains:

#946-513 2 Feet 1. 6-7/8” exible outer liner (Kit length)

2. 4” exible inner liner (Kit length)

3. spring spacers

4. thimble

5. AstroCap termination cap

6. screws

7. tube of Mill Pac

8. plated screws