Renishaw ADTi-100 User Manual

ADTi-100 and ADT View user guide
Contents
1
General information 1
1.1 Overview 1
1.2 Product compliance 2
1.3 Generalspecications 3
1.4 Minimum requirements 3
1.5 ADTa-100 dimensions 4
1.6 ADTa-100 pin-out 4
1.7 ADTa-100 LED indication 4
1.8 ADTa-100 user button 4
1.9 ADTi-100 dimensions 5
1.10 ADTi-100 pin-out 5
1.11 ADTi-100 LED indication 5
2 Connecting the ADT 6
3 Installing and connecting the ADT View software 6
3.1 Installing the software 6
3.2 Connecting to an ADT 7
3.2.1 ADT selection 8
3.2.2 ADT connection errors 9
4 Software settings 9
5 Using the ADT View software with ADTa-100 10
5.1 Position display (DRO) and signal screen 11
5.1.1 Signal strength 12
5.1.2 Digital readout of the encoder position 12
5.1.3 Set Zero position function 13
5.1.4 Alarms and warnings 15
5.2 Signal strength vs position screen 17
5.2.1 Linear systems 17
5.2.2 Rotary systems 19
5.3 Congurationscreen 20
6 Using the ADT View software with ADTi-100 21
6.1 Signal screen 22
6.1.1 Signal strength 23
6.1.2 Reference mark phasing 23
6.1.3 Readhead mode 23
6.1.4 Pitch indication 23
6.1.5 System calibration 24
6.1.6 Alarms and warnings 25
6.2 Lissajous (X-Y) screen 27
6.3 Signal strength versus position screen 28
6.3.1 Signal strength and IRED drive plots 29
6.3.2 Graph controls 30
6.4 Velocity plot 31
6.4.1 Graph controls 32
6.5 Position display (Digital readout) 33
6.5.1 Linear position display 34
6.5.2 Rotary position display 34
6.5.3 DRO controls 34
6.6 Congurationscreen 35
6.6.1 Restore factory defaults 36
7 Troubleshooting 37

Renishaw ADTi-100 Specifications

General

Brand	Renishaw
Model	ADTi-100
Category	Diagnostic Equipment
Language	English