Renishaw ADTi-100 User Manual

2
ADT and ADT View user guide
1.2 Product compliance
C
Renishaw plc declares that the ADTa-100 and ADTi-100 comply with the applicable standards
and regulations. A copy of the EU declaration of conformity is available from our website at
www.renishaw.com/productcompliance
FCC compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. The user is cautioned that any
changesormodicationsnotexpresslyapprovedbyRenishawplcorauthorisedrepresentativecouldvoid
the user’s authority to operate the equipment. This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference
inwhichcasetheuserwillberequiredtocorrecttheinterferenceathisownexpense.
NOTE: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be
used with the unit to ensure compliance.
Further information
Further information relating to the encoder range and installation of the encoder can be found
in the relevant Data sheets and Installation guides. These can be downloaded from our website
www.renishaw.com/opticalencoders and are also available from your local representative. This document
may not be copied or reproduced in whole or in part, or transferred to any other media or language, by any
means without the written prior permission of Renishaw. The publication of material within this document
does not imply freedom from the patent rights of Renishaw plc.
Disclaimer
RENISHAW HAS MADE CONSIDERABLE EFFORTS TO ENSURE THE CONTENT OF THIS
DOCUMENT IS CORRECT AT THE DATE OF PUBLICATION BUT MAKES NO WARRANTIES OR
REPRESENTATIONS REGARDING THE CONTENT. RENISHAW EXCLUDES LIABILITY, HOWSOEVER
ARISING, FOR ANY INACCURACIES IN THIS DOCUMENT.
REACH regulation
Information required by Article 33(1) of Regulation (EC) No. 1907/2006 (“REACH”) relating to products
containing substances of very high concern (SVHCs) is available at: www.renishaw.com/REACH
The packaging of our products contains the following materials and can be recycled.
The use of this symbol on Renishaw products and/or accompanying documentation indicates that
theproductshouldnotbemixedwithgeneralhouseholdwasteupondisposal.Itistheresponsibility
of the end user to dispose of this product at a designated collection point for waste electrical and
electronic equipment (WEEE) to enable reuse or recycling. Correct disposal of this product will help
to save valuable resources and prevent potential negative effects on the environment. For more
information, contact your local waste disposal service or Renishaw distributor.
Packaging
Component
Material ISO 11469 Recycling
Guidance
Outerbox Cardboard Not applicable Recyclable
Polypropylene PP Recyclable
Inserts Low Density Polyethylene Foam LDPE Recyclable
Bags High Density Polyethylene Bag HDPE Recyclable

Renishaw ADTi-100 Specifications

General

Brand	Renishaw
Model	ADTi-100
Category	Diagnostic Equipment
Language	English