Renishaw ADTi-100 User Manual

35
ADT and ADT View user guide
ADTi-100
6.6 Conguration screen
ThecongurationscreenprovidesinformationaboutthereadheadandADTconnected,andallowsfactorydefaultcalibrationvaluestoberestoredinthereadhead(section 6.6.1).
1 Save data
2 Readhead characteristics
• Read from the part number stored in the
readhead
3 Readhead performance
• Theoreticalmaximumspeed,minimumedge
separation (based on a 1 m cable) and
recommended clock speed based on the part
number stored in the readhead
• Calibration status of the readhead
• Temperature of the microcontroller in the
readhead (Temperature is not displayed when
the readhead is in ‘Calibration Mode’)
• Supply voltage at the ‘Encoder Output’ of the
ADT. If the ADT is used in-line, the voltage at
the encoder output connector will be displayed
4 Restore factory defaults (section 6.6.1)
5 Readheadconguration
• Read from the part number stored in the
readhead
• Readhead internal clock frequency
• The alarms and warnings that are enabled in
the readhead are highlighted in orange
6 ADT characteristics
NOTE:Onsmallerwindowsizestheconguration
information will be displayed in tabs
1 2 3 4
6
5

Renishaw ADTi-100 Specifications

General

Brand	Renishaw
Model	ADTi-100
Category	Diagnostic Equipment
Language	English