62
R13=1. Tool broken flag.
Using this flag prevents a BROKEN TOOL or OUT OF
TOLERANCE alarm from being raised.
R19=s s= Spindle speed at which checking for a broken tool takes
place. For details, see “Setting-data subroutine L9760”
on page 13.
Default value: 3150 rev/min.
R25=y y= Radial step-over distance.
The offset across the beam at which measurement of
the tool length takes place.
Default value: On-centre
R26=z z= Safety plane.
The distance (in the spindle axis) to which the tool is
retracted.
Default value: No retract
Outputs
The following output is always set when this cycle is executed:
RENC[48] Broken tool flag.
(2 = long tool, 1 = broken tool, 0 = good tool)
Broken tool detection (plunge check)
To Next Page
Loading...
