Renishaw NC1 - Page 76

74
R13=1. Used to prevent an alarm being raised when the profile
is out of limits.
R14=t t= Tool length offset edge.
This is the offset location in which the measured tool
length is stored.
Default value: Current tool edge.
R19=s s= The spindle speed for the cutter.
This value is used for profile checking when no R03=c
input is used; otherwise, the spindle speed is adjusted
automatically for profile checking.
Default value: 3150 rev/min.
R26=z z= Retract distance after profile checking.
The tool reference point is retracted to this position.
Default value: Retract to the home position
Additional subroutine inputs for radius profile checking
only
R05=j j= Start position adjustment relative to the cutter radius
centre for profile checking (see the figures on page 71).
Range: radial ³ 0 <R18=r input
R11=h h= The height from the tool length offset position to the
bottom of the radius profile, i.e. the J0 position (see the
figures on page 71).
Range: ³ 0
Default value: R06=k value.
Cutter radius and linear profile checking