If stock REVOLECTRIX adapters don’t work for your packs, you can make your own
adapters using the CPBP9P-10 Cellpro battery pigtail 10", 9 position, which consists of a
9-pin connector with un-terminated wires. See Balance connector wiring and the “CellPro
Battery Wiring Diagram” available from the REVOLECTRIX Web site.
Note: above illustrations may read “PowerLab 8” because for purposes of these
illustrations, both models are identical.
See also
Balance connector wiring
XH/EH wiring mode
Note: After a charge is initiated, never alter the connections between the
charger and the battery packs. Always end the current charge session before
making any connection changes. See page 25 for more information about
STARTING and STOPPING charge sessions.
To Next Page
Loading...
