Using the Charge Control Software
About the CCS
The free Dual PowerLab 8x2 Charge Control Software (CCS) gives you unparalleled ability to customize the Dual
PowerLab 8x2. In order to connect the Dual PowerLab 8x2 to the computer and use the CCS, you are required to
use one of the FMA PC USB Interfaces; either the FUIM2 or the FUIM3.
This table lists common CCS tasks. What do you want to do?
Download and install the Charge Control Software
Monitor pack voltage, cell voltage and other data during
Initiate and control charging from CCS
View charge data in real-time graphs
Change graph update interval
View > Preferences > Graphing Update
View cell internal resistance during charging
Monitor supply voltage and current during charging
Specify default power source type, and set power source
Update Dual PowerLab 8x2 firmware
Restore factory User Presets
Configure, save and load Dual PowerLab 8x2 options
Modify User Preset parameters
Show, hide, reorder, save and load presets
Generate a custom fuel table (Fuel Wizard)
Tools > Generate Fuel command
Run multiple CCS instances
To Next Page
Loading...
Need help?
General
