Revolectrix Dual PowerLab 8x2 User Manual

41
Full firmware and preset update process
Over time, new CCS versions and new factory default presets will be released. These
changes may correct safety violations or provide enhanced capabilities that would cause
older presets to contain errors when running in newer firmware or CCS software. This
procedure enables you to update your custom presets as well as the firmware:
1. Back up your custom presets one at a time using the File > Save Preset X to File
command.
2. Update the firmware (see instructions above).
3. Perform a factory restore (see instructions above).
4. Restore custom presets one at a time using the File > Open File to Preset X
command.
5. Check the Errors tab to see whether any of the old presets cause an error in the new
CCS/firmware. Double-click each error and correct the problem.
6. Re-save your custom presets one at a time using the File > Save Preset X to File
command.
Tip: Factory Restore will replace all of the Library and User presets in the DPL
with the latest factory defaults. If you have custom presets designed, back
them up one at a time to your HD for recall later, or consider using the Update
Library tool if you just want the latest Library Presets available in an update.

Revolectrix Dual PowerLab 8x2 Specifications

General

Brand	Revolectrix
Model	Dual PowerLab 8x2
Category	Battery Charger
Language	English