Revolectrix Dual PowerLab 8x2 User Manual

25
Start faster
When following the instructions above, you probably noticed that Dual PowerLab 8x2
asks a lot of questions before it starts a charge, discharge, cycle or monitor. That
enables you to specify exactly what operations Dual PowerLab 8x2 will perform. If all you
want to do is Charge a battery, and once you have a preset configured properly, two
settings in the CCS Options tab will speed up the process:
Activate the Enable Quick Start option.
When activated, Enable Quick Start lets you bypass many of the questions needed to
start a process. After activating this feature, press and hold ENTER if you don’t want to
select options such as discharge/cycle/monitor.
Disable the Choose Power Source at Startup option (only if you consistently use the
same power source).
On startup, Dual PowerLab 8x2 will always use either the DC Power Supply or Battery
profile—whichever was last loaded before disabling the prompt.

Revolectrix Dual PowerLab 8x2 Specifications

General

Brand	Revolectrix
Model	Dual PowerLab 8x2
Category	Battery Charger
Language	English