Sender Settings
97
2
D Enter the PIN Code, and then press the {OK} key.
The standby display appears.
If you make a mistake, press the {Clear/Stop} key before pressing the {OK}
key, and then try again.
E Press the {Start} key.
Note
❒ For the maximum number of digits you can use in a PIN Code, see “Max-
imum Values”.
❒ You can enter numbers, p, q, and pauses.
❒ PIN Codes are not printed in lists and reports.
❒ You can set the machine so that a PIN Code must be entered after the fax num-
ber before you can send a fax. For details, contact your service representative.
Reference
p.186 “Maximum Values”
“Fax Features”, General Settings Guide
To Next Page
Loading...
