Transmission Modes
21
1
If memory runs out while storing an original
If you run out of memory while storing an original (free space reaches 0%), the
“
Memory is full. Scanning will be stopped and only scanned page(s)
will be stored.
” message appears. Press [Exit] to transmit stored pages only.
Note
❒ When this happens, only the scanned pages are sent. If you want to delete the
scanned pages and cancel transmission in this case, contact your service rep-
resentative.
ECM (Error Correction Mode)
If part of a transmission fails because of a line problem, the lost data is automat-
ically resent.
Important
❒ For this function to work, the other machine must have ECM.
❒ This function is not available with Internet Fax.
Immediate Transmission
Immediate Transmission is possible with standard fax transmission and IP-Fax
transmission.
Important
❒ Internet Fax is executed in only Memory Transmission that starts transmis-
sion automatically after storing documents in memory. If you specify Imme-
diate Transmission in Internet Fax, the “
Try again after switching to
memory transmission.
” message appears. When this happens, press [Exit],
and then switch to Memory Transmission.
❒ Group cannot be used for Immediate Transmission. You cannot send the
same document to multiple destinations (broadcasting). If you specify a
group, the “
Try again after switching to memory transmission.”
message appears. When this happens, press [Exit], and then switch to Memo-
ry Transmission.
To Next Page
Loading...
Need help?
General
