Specifying a Destination
49
1
B Enter the fax number using the number keys.
C Press [Tone].
D Enter the number you want to tone dial using the number keys.
E Press the {Start} key.
The transmission starts.
If you want to cancel a transmission, press the {Clear/Stop} key, and then re-
move the originals.
After transmission, the standby display appears.
Note
❒ Certain services may be unavailable even when using the Tone function.
❒ A tone is shown as a “T” on the display and the next numbers are dialed
using tonal signals.
Sending by IP-Fax
This section explains how to specify a destination using IP-Fax transmission.
When using IP-Fax transmission, specify the IP-Fax destination (IPv4 address,
host name, or alias telephone number) in place of the fax number.
Important
❒ To use IP-Fax functions, the optional printer/scanner unit must be installed.
To Next Page
Loading...
