Placing Originals
41
1
C Specify the destination, and then press the {Start} key.
The Stamp indicator goes out when transmission has been finished for Immedi-
ate Transmission or when scanning has been finished for Memory Transmission.
Note
❒ This stamp indicates that the original has been successfully stored in memory
for Memory Transmission, or successfully sent by Immediate Transmission.
❒ When the stamp starts getting lighter, replace the cartridge.
❒ If a multi-page feed or paper jam occurs, the originals are not sent properly
and not stamped. If you find a page that is not stamped, send only that
page again.
❒ A paper jam during Parallel Memory Transmission may cause the trans-
mission to fail even if stamping is performed.
❒ You cannot turn the Stamp function on or off while an original is being
scanned.
Reference
“Fax Features”, General Settings Guide
“Adding Paper and Replacing Toner”, Troubleshooting
To Next Page
Loading...
