Transmission
60
1
Note
❒ Destinations programmed in groups can be checked using “Group Desti-
nation List” in “Administrator Tools” in “System Settings”.
❒ If a destination where a fax number, e-mail address, or IP-Fax destination
is not programmed is included in the specified group, the confirmation
message appears. Press [Select] to specify destinations where the fax num-
ber, the e-mail address, or IP-Fax destination is programmed. Press [Can-
cel] to change the destination. You can select the priority order used to
specify an alternative destination if there is no destination of the specified
type. Make this setting with User Parameters (switch 32, bit 0) in the Fax
Features menu.
❒ To cancel any destination(s) among the group, display the desired destina-
tion using {U} or {T}, and then press the {Clear/Stop} key.
Reference
p.61 “Checking the Specified Destination”
p.186 “Maximum Values”
“System Settings”, General Settings Guide
“Fax Features”, General Settings Guide
“Registering Addresses and Users for Facsimile/Scanner Functions”, Gen-
eral Settings Guide
To Next Page
Loading...
