2.7 UPPER AND LOWER TRAY HEATERS (OPTIONS)
NOTE:
Both heaters are available as service parts.
1. Attach the heater to the bracket (2 M4 x 10 screws).
2. Pull out and remove all the paper feed trays [A] (4 screws each).
3. Install the upper tray heater assembly [B] (2 M4 x 8 screws).
4. Mount the harness in the clamp [C] and connect as shown.
5. Install the lower tray heater assembly [D] (2 M4 x 8 screws).
6. Mount the harness in the clamp [E] and connect as shown.
7. Reinstall the paper feed trays [A].
[A]
[B]
[C]
[D]
[E]
A172/A199 3-32 SM
To Next Page
Loading...
