15.20 PREVENTING THE REAR SIDE OF ORIGINALS FROM
BECOMING DIRTY
NOTE:
Perform the following adjustment only when needed (if the friction
belt needs to be changed but there is no spare friction belt
available). However, after this adjustment, thick originals are likely to
be misfed, so it is best to avoid this adjustment if the customer says
that thick originals will be used.
1. Remove the friction belt assembly. (Refer to Friction Belt Replacement.)
2. Remove the adjusting plate [A] and re-install it as shown (the belt folds
about 1 degree) or remove the adjusting plate (the belt folds about 2
degrees).
[A]
Dual Job Feeder
DF62 (A610)
SM 7-51 A172/A199
To Next Page
Loading...
