15.13 FEED-IN UNIT REMOVAL
1. Turn off the main switch and remove the upper cover. (Refer to Upper
Cover Removal.)
2. Remove the screw [A], then remove the feed cover [B].
3. Disconnect the 2 connectors [C] of the feed-in motor [D].
4. Disconnect the connector [E] of the friction belt motor [F].
5. Disconnect CN104, 105, 108, 109, 110, and 111 on the DJF main board.
6. Disconnect the connector of the indicator panel as well.
7. Remove the feed-in unit [G] (5 screws).
[A]
[B]
[C]
[E]
[G]
[F]
[D]
Dual Job Feeder
DF62 (A610)
SM 7-41 A172/A199
To Next Page
Loading...
