5.2 INSTALLATION PROCEDURE
NOTE:
Holder Type C (A702-18) must be installed before starting the
following procedure.
1. Remove the lower cover [A] from the holder bracket (2 screws).
2. Remove the cover plate [B] from the holder.
3. Install two positioning pins [C] on the holder bracket as shown (2 screws -
M4 x 8) and reinstall the lower cover.
4. Set four spacers [D] at the four corners on the hollow surface of the
holder.
5. Place the projector unit [E] on the holder by aligning the holes of the
projector base plate with the positioning pins.
[C]
[A]
[B]
[E]
[D]
Installation
SM 3-45 A172/A199
To Next Page
Loading...
