15.12 BELT DRIVE MOTOR REPLACEMENT
1. Turn off the main switch and remove the upper cover. (Refer to Upper
Cover Removal.)
2. Disconnect the 2 connectors [A] of the belt drive motor [B].
3. Disconnect the connector [C] of the indicator panel [D] as shown.
4. Remove the tension spring [E] and loosen the tension bracket [F] as
shown.
5. Remove the belt drive motor bracket [G] (3 screws), making sure not to
damage the 2 timing belts [H].
6. Remove the drive pulley [I] (1 Allen screw) then replace the belt drive
motor (4 screws).
[A]
[G]
[I]
[D]
[E]
[B]
[H]
[C]
[E]
[F]
A172/A199 7-40 SM
To Next Page
Loading...
