15.3 FEED ROLLER REPLACEMENT
1. Turn off the main switch and open the feed cover [A].
2. Remove the snap ring [B].
3. Push the feed roller shaft to the front, then remove the roller assembly
[C] as shown.
4. Remove the 4 snap rings, then replace the feed rollers.
NOTE:
When reinstalling the feed rollers, be sure that the one-way bearing
(silver color) is located at the front side (the roller must rotate only
counter-clockwise when the shaft is fixed).
Do not touch the rollers with bare hands.
[A]
[B]
[C]
Dual Job Feeder
DF62 (A610)
SM 7-31 A172/A199
To Next Page
Loading...
