Ricoh A172 - Input Check Mode Table

1.2.10 Input Check Mode Table
NOTE: • Input numbers written in bold italic letters with an asterisk ("*")
are newly added items to the base copier (A109).
• Underlined input number items are the same as the base copier
(A109) but with a different input number.
Input
No.
Sensor/Switch/Signal
Status
01
1
Charge corona leak detection Not detected Detected
2
PCC leak detection Not detected Detected
3
Development bias leak detection Not detected Detected
4
Bk-Development drive motor lock detection Not monitoring Monitoring
(Motor rotating)
5
Color-Development drive motor lock detection Not monitoring Monitoring
(Motor rotating)
6
Drum motor lock detection Not monitoring Monitoring
(Motor rotating)
7
Transport motor lock detection Not monitoring Monitoring
(Motor rotating)
8
Cleaning motor lock detection Not monitoring Monitoring
(Motor rotating)
9
Polygon motor lock detection Not monitoring Monitoring
(Motor rotating)
10
Bk-Sleeve motor abnormal detection Not monitoring Monitoring
(Motor rotating)
11
Y-Sleeve motor abnormal detection Not monitoring Monitoring
(Motor rotating)
12
M-Sleeve motor abnormal detection Not monitoring Monitoring
(Motor rotating)
13
C-Sleeve motor abnormal detection Not monitoring Monitoring
(Motor rotating)
14
Paper feed motor lock detection Not monitoring Monitoring
(Motor rotating)
15
Paper discharge leak detection Not detected Detected
16
By-pass feed table sensor Closed Open
17
Front door safety switches Closed Open
18
LD power supply OFF detection Not detected Detected
19
Vertical transport set switches Closed Open
20
*
Bk - Toner end sensor Not end End
21
*
Y - Toner end sensor Not end End
22*
M - Toner end sensor Not end End
23*
C - Toner end sensor Not end End
24
Toner overflow sensor Not full Full
25
Registration guide set sensor Set Not set
26
Oil end sensor Not end End
A172/A199 4-60 SM