17. Connect the accessory harness connectors [A] to the fan assembly
connectors.
18. Install the fan assembly [B] on the sorter rear frame
(3 screws and 1 connector).
NOTE:
Make sure to run the harness through the cutout [C] as shown.
19. Install the sorter into the mounting holes [D] on the copier while inserting
the sorter harnesses [E] through the opening in the left cover (connect the
2 studs of the copier to the sorter).
20. Attach the sorter to the copier with two screws (2 knob screws [F]).
[A]
[B]
[C]
[D]
[E]
[F]
A172/A199 3-42 SM
To Next Page
Loading...
