3. Install the interface board and harness.
1. If the DJF is equipped on the copier, remove the DJF from the scanner
unit. NOTE: If the DJF is left attached to the scanner you must secure the
scanner unit with the DJF fixing belt [A] as shown.
2. Remove the two fixing screws [B] at the front of the scanner unit.
3. Remove the two fixing screws [C] at the rear of the scanner unit.
4. Open the scanner unit and set the scanner support bar [D] as shown.
5. Disconnect the shielded flat cable [E] and remove the IPU board cover [F]
(2 long and 5 short screws).
6. Remove the harness cover [G] from the right rear corner.
7. Remove the lower rear cover [H] (6 screws) and the lower left cover [I] (4
screws). Then remove the cap [J] from the lower left cover.
[C]
[B]
[A]
[G]
[E]
[D]
[F]
[I]
[J]
[H]
Installation
SM 3-55 A172/A199
To Next Page
Loading...
