18. Secure the interface harness with the three harness clamps and reinstall
the timing belt as shown.
NOTE:
Route the remaining part of the harness along the top of the
AC/DC Drive Board as shown. Position the harness near by the
rear side plate so that the harness won’t touch any moving parts
such as timing belts and motors.
19. Reassemble the machine.
4. Connect to the Fiery and adjust the printer gamma.
1. Connect the Fiery controller to the controller interface connector with the
cable provided from EFI.
2. Adjust the
γ
correction data for printer (See Section 5) and check the
controller function.
A172/A199 3-58 SM
To Next Page
Loading...
