6
. Open
[2]SP Test, page 2.
7
. Select "
Full Dot Pattern
" [A] in
Pattern selection
and select "
Set
" [B] in
Test Pattern Condition
.
8
. Touch the "Copy in SP" key and select "
Black
" copy mode.
9
. Touch the "SP MODES" key and open [2]SP Test, page 5.
10
. Start the
Printer Free Run
by touching "
ON
" [C] and wait for 6 to 7
minutes.
11
. Stop the Printer Free Run by touching "
OFF
" [D].
12
. Open [2]SP Test, page 2 and select "
Reset
" [E] for
Test Pattern
Condition
.
13.
Wait for 5 minutes
and open [2]SP Test, page 4.
14. Perform
Process Control Selfcheck
by touching "
Start
".
15. Check the result of Process Control Selfcheck referring to the installation
procedure and exit the SP mode.
16. Perform Auto Color Calibration.
Rev. 1/16/97
[E]
[A]
[B]
[C] [D]
A172/A199 5-12 SM
To Next Page
Loading...
