– Using The Copier SP Mode –
NOTE:
1) When performing this adjustment, always make test copies with
the "Copy In SP" mode. If you do not, the adjustment will not be
performed properly.
2) Make sure that the DJF dip switches are returned to the standard
setting of the base copier, if you have performed the adjustments
using the DJF main board.
3) Make sure that the "Thin Mode" is selected with the customer
settings of the base copier.
1. Turn the copier main switch off and on to initialize the machine.
2. Enter the copier SP mode, and open the DJF Registration Adjustment
page.
3. Place a sheet of A4/8
1/2
" x 11" sideways paper (64 g/m
2
, 17 lb) on the
original table, and press the Copy In SP key.
To save toner, select BLACK and A4, then press the Start key.
4. After the original stops on the exposure glass, raise the DJF carefully so
that the original does not move.
5. Check that the gap between the trailing edge of paper and the left
original scale is 0 ± 2.0 mm.
6. If the gap is not within this specification, adjust registration by pressing
the
and
keys of the thin mode inside the SP mode. The original
paper stopping position will change accordingly. (If you press
, the
gap will decrease.)
7. Return the user settings to their defaults, if you have changed any.
Dual Job Feeder
DF62 (A610)
SM 7-47 A172/A199
To Next Page
Loading...
