– Using the Copier SP Mode –
NOTE:
1) When performing this adjustment, always make test copies using
the "Copy In SP" mode. If you do not, the adjustment will not be
performed properly.
2) Make sure that the DJF dip switches are returned to the standard
setting of the base copier, if you have performed the adjustments
using the DJF main board.
1. Remove the copier’s left original scale (2 screws).
2. Turn off and on the copier main switch to initialize the machine.
3. Enter the copier SP mode, and open the DJF Registration Adjustment
page.
4. Place a sheet of A4/8
1/2
" x 11" sideways paper (64 g/m
2
, 17 lb) on the
original table, and press the Copy In SP key.
Select the two-sided original mode to invert the original paper. Also to
save toner, select BLACK and A4 size paper. Then press the Start key.
5. After the original stops on the exposure glass, raise the DJF carefully so
that the original does not move.
6. Check that the distance between the trailing edge of the paper and the
left edge of the rear original scale is between 15 ~ 20 mm.
7. If the distance is not within this specification, adjust the registration by
pressing the
and
keys of the two-sided mode inside the SP
mode. The original paper stopping position will change accordingly. (If
you press
, the original will be fed more towards the left.)
Dual Job Feeder
DF62 (A610)
SM 7-49 A172/A199
To Next Page
Loading...
