Field Engineering Bulletin
Digital Color Series
TECHNICAL OPERATIONS
BULLETIN NO: SDC206 – 014 DATE: 4/14/98
Copy Quality
Model - Product/Serial Numbers
Affected
Modification Schedule
Electrical
SDC206
Mandatory
Mechanical Scheduled Visit
Modification
SDC206E
Next Call
Safety Information Next PM
Technical Information As Necessary
General Information Install Time __________
The following modification has been made to the fusing unit to reduce hot roller damage by the stripper pawls
when paper jam occurs in the fusing unit. These improvements were made from October ‘97production
machines. For cut-in serial number, please refer to the Parts Modification Bulletin.
Slider Hot Roller Stripper
The slider hot roller stripper has been modified to prevent the stripper from being pushed too hard into the hot
roller by jammed paper. The part number has been changed from A1094204 to A1724205.
When replacing the slider with a new part, loosen the two screws and remove the hot roller stripper springs as
shown in the below figure. Apply some grease on the slider to the area where it contacts with the front and rear
frame of the paper exit unit.
Savin Corporation Page 1 of 2
Technical Service Operations – P.O. Box 10270, Stamford, Connecticut 06904 --- (203) 967-5000
Subject: HOT ROLLER DAMAGE
To Next Page
Loading...
