2000/3000-sheet Finishers (D373/D374)
D062/D063/D065/D066 2-64 SM
center-position stapling option is displayed.
1. Press the User Tools key.
2. Touch “Copier/Document Server Features”.
3. Touch the “Input/Output” tab, then touch “Stapling Position”.
4. Touch any “Stapling Position” button and touch the center (saddle-stitch) stapling
symbol.
5. Exit the User Tools mode. Specify the number of copies, touch the center stapling
symbol on the operation panel, then start the print job.
Auxiliary Trays
The auxiliary trays are stored in the auxiliary tray storage pocket mounted on the back
cover of the finisher.
Make sure that the customer understands the following points about these auxiliary trays:
The trailing edges of excessively curled or Z-folded paper can activate the tray full
sensors before the tray is actually full.
Once the "Exit Tray Full" message displays, the job cannot continue until some sheets
are removed from the tray which is only partially full. The trays are designed to prevent
this problem.
The auxiliary tray for the shift tray should be installed for Z-folding jobs.
The auxiliary tray for the proof tray should be installed only when excessively curled
paper is triggering early "Exit Tray Full" alerts.
Normally, both auxiliary trays should be placed in the pocket mounted on the back of
the finisher.
Proof Exit Auxiliary Tray
Follow the procedures below to install the auxiliary tray for the proof tray.
1. First, remove the paper from the paper feed tray, turn it upside down, and continue
printing. This may solve the problem.
To Next Page
Loading...
Need help?
General
