MFP Options
D062/D063/D065/D066 2-108 SM
operation is not guaranteed if this type of SD card is used.
The SD card is the only evidence that the customer is licensed to use the
application program. Also, the service technician may occasionally need to check
the SD card and its data to solve problems. For these reasons SD cards must be
stored with the machine.
A licensing agreement prohibits copying of the PostScript SD card. However, you
can copy any application from another SD card to the PS3 SD card.
After an SD card has been used to move other applications onto that card, that SD
card cannot be used for a different function.
Never remove the System SD Card from Slot 1
Before uploading to an SD card, always make sure that the write-protect switch is
OFF. (It is very easy to accidentally turn on the write-protect switch when inserting
or removing an SD card.)
Merging Applications
Do this procedure to put more than one application on one SD card.
1. Turn off the main machine.
2. Remove the SD card slot cover (
x 1).
3. Put the Source SD card in Slot 2 (service slot). This card contains the application that
you want to copy.
The PS3 SD card cannot be the source card (it cannot be copied).
4. Check the target SD card and confirm that its write-protect switch is OFF.
5. Insert the Target SD card into the SD card Slot 1.
6. Open the front door.
7. Turn the main machine on.
8. Do SP5873 001.
9. Touch "Execute".
10. Follow the instructions on the display and touch "Execute" to start copying.
11. When the display tells you copying is completed, touch "Exit".
12. Turn the main machine off.
13. Remove the Source SD card from Slot 2. Leave the target SD card in Slot 1.
14. Turn the main machine on.
15. Go into the User Tools mode and check that all the applications on the SD card in Slot
1 are enabled:
User Tools> System Settings> Administrator Tools> Firmware Version
16. Turn the main machine off again.
Rev. 08/03/2009
To Next Page
Loading...
Need help?
General
