Service Program Mode Tables
D062/D063/D065/D066 4-8 SM Appendix
D066: [5 to 50/14/1 s]
004 Web Near End Value
Adjusts the timing of the web near end alert by changing the amount of web
that has been used before the alert is triggered.
[0 to 100/80/1 %]
005 Web Roll Coefficient
Determines the coefficient of the web take-up time from cleaning toner from the
roller while taking into consideration the take-up time for web buckle. DFU
[10 to 20/9/1]
006 Web Length (0: 20m 1: 22.7m 2:28.5m 3:32m)
Set the length of web.
[0 to 3 / x /1]
D062/D063/D065: x = 3, D066: x = 2
1903* Web Job End
001 Yes/No
This determines whether the web motor is driven at the end of a job.
[0 to 1/1]
0: Off
1: On
Enable when too much paper dust is causing copies to blacken.
002 Job End Condition (Continuous PPC Time)
At the end of a job, the web motor is driven if the job lasted longer than the value
of this SP mode. Only valid if SP1903-001 is set to 'On'.
[1 to 99/7/1s]
003 Job End Frequency
If the web motor is driven at the end of a job, this SP determines how many
times the web motor operation is executed.
[1 to 5/2/1]
To Next Page
Loading...
Need help?
General
