Service Program Mode Tables
SM Appendix 4-35 D062/D063/D065/D066
Appendix:
Service
Program
Mode Tables
[–30 to +30/20/1 mm]
022
Leading Edge:
After Punch
Adjusts the area where transfer current is applied for the
leading edge during copying with punch.
[0 to +20/0/1 mm]
023
Trailing Edge:
After Punch
Adjusts the area where transfer current is applied for the
trailing edge during copying with punch.
[0 to +20/0/1 mm]
024
Off Timing: After
Punch
Adjusts the transfer current OFF timing for copying with
punch.
[–30 to +30/-16/1 mm]
2940* Reface Mode
Determines if a blade bend prevention pattern is made when the ID sensor
pattern is made. This setting controls the pattern count. DFU
[0 to 100/0/1]
Increase the setting if the rotation of the drum is not smooth, that is, when drum
rotation is making noise.
2950 Vh Pattern Create
Vh Pattern Creation Setting DFU
001 Exposure Level
[0 to 15/7/1]
002 Offset Light Amount
[-100 to 0/-45/1]
Process Interval Additional Time. DFU
2960
[0 to 7/0/1 sec]
2961
Developer Adjust Mode DFU
2962 Automatic Adjustment of Drum Conditions
To Next Page
Loading...
Need help?
General
