4. Select the number of the program in which you want to register the settings.
Program numbers with already have settings in them.
5. Enter the program name.
6. Press [OK].
The Program screen reappears. When the settings are successfully registered, appears on the left
side of the registered program number and the program name appears on the right side. The initial
screen reappears after a moment.
Recalling a Registered Content
To recall settings registered in a program and use them for scanning:
1. Press the [Program] key.
2. Press [Recall].
3. Press the number of the program you want to recall.
Settings registered in the program are recalled and the initial scanner screen reappears.
Settings are not registered in numbers that appear without .
4. Place originals, and then press the [Start] key.
Changing a Registered Program
To change the settings registered to a program:
1. Press the [Program] key.
2. Press [Recall].
3. Press the number of the program you want to change.
Settings registered in the program are recalled and the initial scanner screen reappears.
4. Change settings of the program.
8. Various Scan Settings
176
To Next Page
Loading...
