etherauth
Use "Ethernet" command to display or modify the authentication related parameters for Ethernet.
View settings
msh> etherauth
802.1x Configuration
msh> etherauth 8021x {on|off}
• {on} means "active" and {off} means "inactive".
help
Use the “help” command to display the available command list and the procedures for using those
commands.
Command list display
msh> help
Display of procedure for using commands
msh> help “command_name”
hostname
Use the “hostname” command to change the printer name.
View settings
msh> hostname
IPv4 Configuration
msh> hostname “interface_name” “printer_name”
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning “RNP” (in either upper or lower case).
• The Ethernet interface and IEEE 802.11 interface will have the same printer name.
• wlan can be specified only when the IEEE 802.11 interface is installed.
• If you do not specify an interface, the Ethernet interface is selected automatically.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Remote Maintenance by telnet
175
To Next Page
Loading...
