bonjour
Use the “bonjour” command to display bonjour-related settings.
View settings
Bonjour settings are displayed.
msh> bonjour
Bonjour service name setting
You can specify the bonjour service name.
msh> bonjour cname “computer name”
• The computer name can be entered using up to 63 alphanumeric characters.
• If you do not specify a character string, the current setting is displayed.
Bonjour Installation location information setting
You can enter information about the location where the printer is installed.
msh> bonjour location “location”
• Information about location can be entered using up to 32 alphanumeric characters.
• If you do not specify a character string, current setting is displayed.
Setting order of priority for each protocol
• msh> bonjour diprint [0-99]
• msh> bonjour lpr [0-99]
• msh> bonjour ipp [0-99]
You can specify the order of priority for “diprint”, “lpr”, and “ipp”. Smaller numbers indicate higher
priority.
IP TTL setting
msh> bonjour ip ttl [1-255]
You can specify the IP TTL (the number of routers a packet can pass through).
• The default is 255.
Resetting the computer name and location information
You can reset the computer name and location information.
msh> bonjour clear {cname|location}
• cname: Reset the computer name. The default computer name will be displayed when the
computer is restarted.
• location: Reset the location information. The previous location information will be deleted.
Interface configuration
msh> bonjour linklocal “interface_name”
4. Monitoring and Configuring the Printer
168
To Next Page
Loading...
