10. Select the functions to be used with the user code from "Available Functions".
11. Press [OK].
12. Press [Exit].
13. Press the [User Tools/Counter] key.
• You can enter a one-to eight-digit user code.
• To register the name, see "Registering Names".
• p.245 "Registering Names"
Changing a User Code
This section describes how to change a user code.
• Even if you change a user code, the counter value will not be cleared.
1. Press the [User Tools/Counter] key.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [Address Book Management].
Authentication Information
251
To Next Page
Loading...
